Soran Khalil

Experience

• 

  Fanoos Telecom

  Jun 2011 - Dec 2012

  BSS Engineer

  • June 2011 – December 2012 BSS Back Office Engineer(FANOOS TELECOM) Telecommunication Company.Scope of work done:• Installation, commissioning, configuring Suly & Kirkuk BTS.• Supervising a team of 4 technicians responsible for scheduling and conducting Preventive Maintenance Routine.• Prepared and presented information and data about WiMAX and CDMA Systems.• Collected uploaded and downloaded subscriber data• Computerized management maintenance system • Monitored and configured all (WiMAX & CDMA) BTS Sites• Familiar with M2000 server for management, monitoring, configuring and upgrading license• Familiar with AP Manager Server for Upgrading licenses and configured BTS, WiMAX and CDMA.• Preparation of Weekly & Monthly Reports. Show less

• 

  TAURUS ENERGY

  Jan 2013 - now

  Lead Electrical Engineer

  Scope of work done:• Supervising a team of 15 technicians responsible for scheduling and conducting Preventive Maintenance at the Refinery. • Participated in Refinery Safety procedures and protocols training sessions to ensure a safe and healthy environment for team members• Adhering to hot and cold permit of work system to ensure safety.• Monitoring, inspection and energizing of Fire Diesel Engine.• Acting as a liaison with contractors for construction of a new laboratory.• Acting as a liaison with NPC contractor for turnkey basis refurbishment and rehabilitation of 132/11kV, 15MVA Mobile Substation to national grid including overhaul maintenance, testing, commissioning and energizing. • Connecting variable frequency drive VFD to DCS by using both serial communication RS485 and analog output 4-20mA to control the speed of fin fans. • Installing and Configuring VFD drive for kind of motors.• Solving Problems in Gasoline Block, Pre-Flash & CDUs Units using root cause analysis.• Participated for LV, MV, HV Switchgear Maintenance and Protection Course in Dubai.• Attended a training course for Introduction to Mobile Transformer Substation 132/33KV 16MVA.• Attend on the training course for SHAFT ALIGHNMENT AND VIBRATION MEASURMENT.• Involved in Factory acceptance test (FAT) 6.6kV switchgear (ATS) with RTCCP in Amman.• Monitoring Electrical Parameters of power distribution system.• Fabricating electrical panels. • Physical inspection of site equipment’s for maintenance and troubleshooting.• Heat trace panel installation, commissioning, inspection and monitoring.• Power transformer installation, inspection, testing, and monitoring.• Motor Bearing inspection by using fluke-805 and replacing.• Battery inspection by using advanced battery analyzer fluke-BT521 to determine early stage of failure.• Commissioning, monitoring and inspection of Carrier HVAC systems.• Incident investigation & report close-out with preventive actions. Show less