Tivere Okpegwa

Experience

• 

  Solewant Nigeria Limited

  Sept 2014 - Jan 2017

  Coating Inspector

  3-Layer PE of 18" Pipes (Seplat Petroleum Development Company)Indorama Gas Pipeline Project. Morpol Engineering (CWC of 10km)Quality monitoring/documentation of climatic conditions like temperature, humidity, prior/post coating of the pipe bendsQuality monitoring/documentation of pipe surface conditions like surface profile, surface temperature, dust/oil/grease/salt contamination of damaged coated pipes during coating of pipe bends.Holiday detection test on 3LPE coated pipesVisual inspection and dry film thickness measurements Ensure the plant application of 3 LPE is done as per specification including performance all relevant tests to ascertain integrity of coated pipes Mostrar menos

• 

  Procoating Nigeria Limited/ Total E & P

  Jan 2017 - Jan 2017

  Coating Vendor Representative

  Routine Maintenance of FSO UNITY/ OML 100 Deck Offshore (M 04 C Coating System)Generic paints used were Epoxy Mastic(Carbomastic 15), Glass Flakes Filled Epoxy(Carboguard 1209 GF) and Polyurethane(Carbothane 134)Made sure surface was thoroughly degreased with Carboline Surface Cleaner #3, followed by fresh water rinseEnsured accurate documentation and reporting of all activitiesTechnical assistance in the application of Carboguard 1209 GF

• 

  Procoating Nigeria Limited

  Feb 2017 - Jan 2021

  Coating Inspector/Technical Sales Coating Engineer

  Carboline Coatings and Linings. Technical assistance to clients.

• 

  Mothercat Nigeria Limited

  Nov 2017 - Mar 2020

  Coating Inspector

  Zaria City Water Reservoir (4.5 Million Litres Water Tanks).Generic paints used were IOZ(Carbozinc 11), Epoxies(Carboguard 703, 893 SG and 893 ZA) and Polyurethane(Carbothane 134)Conduct inspections, tests and measurements of ambient conditions, surface profile, cleanliness, dry film thickness and holiday detection to verify adherence with regulations and desired specifications.Carry out blotter test(ASTM D 4285), dust test(ISO 8502-3) pull-off adhesion test(ASTM D4541) and salt test using bresle patch(ISO 8502-6,9)Ensure blasting & coating activities during fabrication is in accordance with design & minimize non-conformance of painting resultsProvide technical direction to top management and field staff Preparation of QC Procedures, Work Instructions, Inspection and Test Plans with respect to client specificationRaise Non Conformance Reports on product activities, expedite corrective / preventive actionBeing part of project specification review team throughout project construction phase. Review of coating specifications, standards, Product data sheets and Safety data sheet.Ensure full compliance with HSE requirements for all coating and Painting activities carried out safety compliance at work site.Coordinate day to day inspections of surface preparation and painting work, ensuring that surfaces are prepared to specification and that coating are applied in the correct order, to the required thickness. Ensure accurate documentation and reporting of all activities Mostrar menos

• 

  FAIRTEX INTEGRATED SERVICES LIMITED

  Jan 2022 - Oct 2022

  Coating Supervisor

  Routine Maintenance OML 102 OFON (TOTAL Energies)

• 

  Montego Group

  Nov 2022 - Sept 2024

  Coating and Insulation Inspector

  Rehabilitation of Port Harcourt Refinery, Nigeria. High Temperature Coatings Application and Insulation on Heat Exchangers, Drums, Columns, Heaters and Pipelines.

• 

  Chevron

  Jun 2024 - now

  Coating Inspector