Akmaluddin Adam

Experience

• 

  Siemens

  May 2023 - May 2025

  - HMI configuration and development using WinCC Software for automation systems, reducing load work of engineer time usage by 15% through assisting the project.- HMI configuration and development using TIA Portal, integrated with RTUs, IED Relay , improving system diagnostics and visualization accuracy.- Assisted in configuration of ethernet switch (Ruggedcom) for 3 substations, enhancing network reliability and reducing downtime incident.- Configured SICAM A8000 RTUs with I/O mapping, communication setup (IEC 104), and device addressing, contributing to successful automation system integration across the substations.- Prepared I/O List for SCADA and automation systems, covering more than 500 signals across 5 projects, ensuring smooth integration and commissioning.- Compiled TIP List for PLN in Excel for 3 FAT/SAT activities, streamlining progress tracking and improving test documentation efficiency.- Assisted in configuration and parameterization of 3+ SICAM A8000 Remote Terminal Units (RTUs) for substation automation, enabling reliable data acquisition and control integration into the SCADA system via IEC 60870-5-104 protocol.- Participated in various system engineering trainings, including RTU configuration (SICAM A8000), SICAM PAS & PQS system setup, and Cisco networking fundamentals, enhancing technical proficiency in substation automation, power system monitoring, and industrial communication networks. Show less - Created Single Line Diagrams (SLD) and schematic wiring diagrams for relay control panels, contributing to 10+ project completions and reducing load work of engineer by approximately 30%.- Designed panel layouts including front view and internal wiring layout, used in over 10+ project, accelerating construciton panel time by 20% through optimized space usage.- Assigned proper tagging and labeling for wiring and components inside the panel, ensuring 100% compliance with documentation standards- Assisted in Factory Acceptance Test (FAT) and Site Acceptance Test (SAT) for 5+ substations, helping identify and resolve 10+ technical issues pre-commissioning- Configured 5+ SIPROTEC 5 protection relays using DIGSI 5 Software for overcurrent and differential protection schemes.- Set up substation automation system based on IEC 61850, including GOOSE messaging and MMS communication mapping across 3 Intelligent Electronic Devices (IEDs), improving system interoperability and reducing wiring by 40%.- Assisted in drawing of general arrangement and ringloop drawing of relay control panels, improving collaboration with engineering teams and reducing revision cycles by 25% Show less

  • System and Solution Engineer Intern

    May 2024 - May 2025

  • Electrical Design Engineer - Intern

    May 2023 - Apr 2024