Ahmad Aqil Safwan Bin Ahmad Zabidi

Experience

• 

  Hoya

  Nov 2017 - Apr 2018

  Maintenance Technician

  • Run daily maintenance for the production machine by changing/refilling the oil, and inspecting the machine sensor and meter to ensure it usually runs.• Run monthly maintenance for the production machine by changing the grease, oil, bearing and another part of the machine that needs to be replaced.• Service some of the machine parts that can be reused, such as pressure pump and filter.• Personal project assigned by the Engineer: I was ordered to assemble a distribution board of 3 phase setup from scratch to be used at the maintenance bay. Show less

• 

  SilTerra Malaysia Sdn. Bhd.

  Mar 2022 - now

  • Tool owner for HDP-CVD and PECVD process chamber.• Overseeing the thin-film dielectric layer and Trimming process for the 8-inch wafer.• Perform electrical, pneumatic, hydraulic or mechanical troubleshooting to maintain the equipment used.• Performing PM, diagnosis and analysis on production equipment tools.• Support new equipment installation, sustaining and process improvement initiatives.• Resolving non-standard problems with minimal supervision.• Manage maintenance, design, improvement, and upgrade activities for the production equipment tools. Show less • Provide process control engineering support to operation and maintenance organisations.• Support and maintain control system maintenance for PLC and SCADA (HVAC system).• In charge of the Fan Filter Unit (FFU) monitoring system project. This project is under the HVAC system to supply cold air to the SilTerra FAB plant.• Design a SCADA layout using FactoryTalk View Site Edition (Allen Bradley) for the FFU project.• Setup and configure 1000 units of Power Flex 525 AC Drives (AB) used on the FFU project to control and monitor the system.• Use Studio 5000 Logix Designer (AB) to configure the VFD and design a ladder logic diagram for the FFU project.• Install and setup PLC ControlLogix 5580 (AB) unit for the FFU project• Controlled and monitored the FFU project to ensure all the fans were in good condition.• Manage maintenance, design, improvement, and upgrade activities for the FFU project. Show less

  • Senior Equipment Engineer

    Nov 2024 - now

  • Equipment Engineer

    Aug 2022 - Nov 2024

  • Facilities Engineer

    Mar 2022 - Aug 2022